欢迎访问北京尚丰祥食品机械有限公司网站!

热线:13693237787 

沙拉加工教你切菜机如何更换刀盘?

来源:https://www.sfxjxbj.com/ 浏览量: 时间:2020-11-27 13:55:35

切菜机如何更换刀盘?怎么调节?
How to change the cutter head? How to adjust?
下面就让小编为大家简单介绍下切菜机的调节方法:
Let's briefly introduce the adjustment method of the chopper for you
在上下输送带动上共有四个小调节旋钮。上面两个调节上输送带的松紧,右(后)面两个旋钮调节下面长输送带的松紧。
There are four small adjusting knobs on the upper and lower conveying drive. The upper two adjust the tightness of the upper conveyor belt, and the two knobs on the right (rear) side adjust the tightness of the lower long conveyor belt.
此机通常配置的刀:①牛角刀 (常规刀具)
This machine is usually equipped with knives: ① horn knife (conventional tool)
   沙拉加工设备
警告:
Safety warning:
1、在使用机器前,必须仔细阅读说明书,特别是机器的方面,这样有助于减少机器或者人员受到伤害。设备上的警告“waring”和“Cauting”,“Warning”主要是指对人员和机器都产生伤害的情况,“Caution”主要是指对设备产生的。
1. Before using the machine, you must carefully read the instructions, especially the safety aspects of the machine, so as to reduce the harm to the machine or personnel. The warning "warning" and "warning" on the equipment refer to the situation that the personnel and the machine are injured, and the "caution" mainly refers to the equipment.
2、在维修和保养前,请务必关掉电源,否则可能造成人身伤害,并由专人负责。
2. Before repair and maintenance, please turn off the power supply, otherwise personal injury may be caused, and special personnel shall be responsible for it.
3、要定期检查,确认机器是否正常运转,并防止设备可能出现的短路或者漏电等情况。
3. Regular inspection should be carried out to confirm whether the machine is in normal operation and to prevent possible short circuit or electric leakage of the equipment.
4、此机由于是刀片高速转动,所以操作人员千万不能用手放在出料口.清理菜叶,可以用木制的器具清理。
4. Since the blade of this machine is rotating at a high speed, the operator must not put his hands on the outlet. The vegetable leaves can be cleaned with wooden tools.
5、清洗刀具时应戴上手套,以免割伤手指。
5. Wear gloves when cleaning tools to avoid cutting fingers.

北京尚丰祥食品机械有限公司

备案号:京ICP备13030550号-2